Daisy Patch Submodule

Official Announcements
42

Will the schematic be available ?

43

We’re working on a new version of the datasheet which will show the schematic connections between the pinout and the MCU.

44

Also curious about the +3v3 and +5v supplies - any idea what the current output on them is?

45

+5V: 800mA
+3V3: 500mA

For future reference, these pins are specced in Table 1 in the datasheet (p2).

1 Like
46

Hi
My Daisy Submodule is in the post!
I’ve already downloaded the gerbers and printed off the control board.
Is there any way to get the gerbers/design files for the front panel?
Thanks

48

I based mine off this one when I built a Patch.init():

49

Hello, any news about adding the ST Link Debugger? I don’t know where to solder. Just bought a ST Link Mini but really don’t know very much on hardware. I can solder, no problem for that I’d like to see this post earlier to also order the missing male pin to solder
Thanks

50

I’m not sure what you have, patch.Init() or Daisy Patch Submodule. The init is supposed to come with a jtag header. The submodule does not, perhaps this is what you’re looking for: