Hey Justin!
Yes, CV is added to the knob position. The ADC Inputs section of the Daisy Patch schematic is a great reference.
This forum post/thread also explains it too: Daisy Patch Input CV voltage and Control Knobs - #2 by shensley
I may have misinterpreted OP’s question on this thread that they wanted to connect the CV input and knob to a single ADC in a more independent direct way (so without adding the CV to the knob position and such). It’s been few months, so I don’t remember exactly how I was interpreting the question, but I’ll edit that post to clarify more.
Thanks for bringing this up 