Terminal command to reboot/reset?

[tunagenes]

And just ‘for the record’ here’s an answer to @sroons original post, years later:

BOOT_FLASH attached to a pin?

It is connected to PORTG pin3, accessible via libdaisy as dsy_gpio_pin boot_pin = {DSY_GPIOG, 3}; You should be able to pull that pin high in software, and then do a software reset. The cap in the schematic is there to hold the voltage high during that reset so that it will boot into the bootloader. pseudocode: void RebootToBootloader() { // Initialize Boot Pin dsy_gpio_pin bootpin = {DSY_GPIOG, 3}; dsy_gpio pin; pin.mode = DSY_GPIO_MODE_OUTPUT_PP; pin.pin = bootpin; d…